TC-1, TC-3 tilt switch tilt level switch TC-1, TC-3 tilt switch tilt level switch TC-1, TC-3 tilt switch tilt level switch TC-3. The working principle of the tilt level switch is to hang the sensor in the tank compartment with a cable. When the material piles up and causes the sensor to tilt, it receives a switch and outputs a signal. After the pile is lifted, the contact signal returns to the initial state. There is a metal ball inside the main body of the tilt switch. When it remains vertical, the metal ball is in the center position and the micro switch is pressed. When the main body tilts more than 17 °, the metal ball rolls and leaves the micro switch, outputting the contact signal TC-1 Technical Parameters Heavy& nbsp; Quantity: approximately 11kg (cast iron casing) Two wire contact output: SPDT x 1 Contact capacity: 250VAC; 10A working temperature: -10 ℃~+120 ℃ (without condensation or icing) Protection level: IP56 Outlet: 1/4~3/8 inch cable, 1/2 inch screw TC-3 Technical parameters weight& nbsp; Quantity: Approximately 1.3kg (cast aluminum shell) Two wire or three wire contact output: SPDT x 1 Contact capacity: 250VAC; 10A working temperature: -10 ℃~+80 ℃ (without condensation or icing) Protection level: IP56 Outlet: 1/4~3/8 inch cable, 1/2 inch screw
LJ22A3-8-Z/BY  SC3020A  LJ38A4-18-J/EDZ LJ38A4-18-J/DZ  LJ38A4-18-J/EZ  LJ38A4-18-Z/DX  LJ38A4-8-Z/EX LJ38A4-18-Z/CY  LJ38A4-18-Z/AY LJ38A3-18-Z/BY  LJ38A4-18-Z/CX LJ38A4-18-Z/AX  LJ38A4-18-Z/BX  LJ22A3-8-J/EDZ  LJ22A3-8-J/DZ  LJ22A3-8-J/EZ  LJ22A3-8-Z/DX