Installation of Material Level Tilt Switch ExLVG-S Material Level Tilt Switch ExLVG-S 1. Installation of Material Level Meter Probe Due to the cylindrical shape of the material level detector probe and the universal action of the internal mercury switch, the working direction is not restricted. Users can hang the probe at an appropriate position on the top of the material pile according to the height of the material in the silo or material yard (material level) (note: the probe should avoid the falling point). The specific method is as follows: ① When detecting the high material level in the silo, the lifting ring of the probe is welded to the iron pipe, and the cable is connected to the control box through the iron pipe. The length of the iron pipe is determined by the user according to the actual situation (the recommended size of the iron pipe is greater than 20mm inner diameter). Working principle: The working process is that when the material in the yard accumulates to the installation height of the material level meter probe, it touches the material level meter probe to tilt it to the working angle, and the mercury switch is disconnected; LJ24A3-8-Z/BX  LJ24A3-8-Z/AX  LJ24A3-8-Z/CX  LF24A3-8-Z/BY  LJ24A3-8-Z/AY  LJ24A3-8-Z/CY  LJ24A3-8-Z/DX  LJ24A3-8-J/EZ   LJ24A-8J/DZ  LJ24A3-8-J/EDZ  LJ30A3-10-Z/BX  LJ30A3-10-Z/AX  LJ30A3-10-Z/CX  LJ2P-15G/214  LJ2L-154/113  GDN15-CT5W  TCA-3050C  LJ2P-15G/211